Home Caution: If you have items in your cart, just close this window when finished.
*SAFETY WARNING* ALL MANUFACTURERS WARRANTIES ARE VOIDED WHEN GO-PED® IS CHANGED OR MODIFIED IN ANY WAY. INCREASING THE SPEED OF THE GO-PED® IS AT YOUR RISK ONLY. THIS HIGH PERFORMANCE MODIFICATION IS INTENDED FOR EXPERIENCED GO-PED® RIDERS AND ONLY WITH COMPLETE SAFETY GEAR.THESE INSTRUCTIONS ARE PROVIDED AS A MEANS OF REFERENCE AND ARE TO BE USED SOLELY AT YOUR OWN RISK.Meyer Distributing®, LLC is not responsible for any outcome, favorable or not, that may occur by utilizing the following procedures.

 !  T-6 Flywheel Puller

Remove fan cover
Remove flywheel nut.
With the puller bolt use either of the two small holds on the flywheel, thread the bolt in until it hits the case, being careful not to damage them. Tighten slowly and the flywheel will come loose.

 !   Technical Articles
HP Carburetor Kit Installation
Air Filter Oiling
T-6 Flywheel Puller
Tanaka Timing Advance Key
Zenoah Timing Advance Key
Goped Wheel Adjustment
Goped Tire Replacement
High Performance Carburetor Installation and Tunings
General High Performance Carburetor Tuning
G230RC G260 SK27 HE26 TUNING
Spindle Removal
Alcohol Methanol