Home Caution: If you have items in your cart, just close this window when finished.
*SAFETY WARNING* ALL MANUFACTURERS WARRANTIES ARE VOIDED WHEN GO-PED® IS CHANGED OR MODIFIED IN ANY WAY. INCREASING THE SPEED OF THE GO-PED® IS AT YOUR RISK ONLY. THIS HIGH PERFORMANCE MODIFICATION IS INTENDED FOR EXPERIENCED GO-PED® RIDERS AND ONLY WITH COMPLETE SAFETY GEAR.THESE INSTRUCTIONS ARE PROVIDED AS A MEANS OF REFERENCE AND ARE TO BE USED SOLELY AT YOUR OWN RISK.Meyer Distributing®, LLC is not responsible for any outcome, favorable or not, that may occur by utilizing the following procedures.

 !  G230RC G260 SK27 HE26 Tuning

There are 3 screws with springs. Follow the trouble shooting part of “H/P CARB” section.
There are 2 black screws with springs located on the pullstart side of the motor. The one closest to the cylinder is the low end screw. Turn it all the way in, then back it out 1 ¼.
The one next to it is the high end screw. Turn it in and back it out 1 ¾.
Turn the bottom big Phillips screw with spring all the way in and leave it in.
Tune it according to the H/P tuning section.

 !   Technical Articles

HP Carburetor Kit Installation
Air Filter Oiling
T-6 Flywheel Puller
Tanaka Timing Advance Key
Zenoah Timing Advance Key
Goped Wheel Adjustment
Goped Tire Replacement
High Performance Carburetor Installation and Tunings
General High Performance Carburetor Tuning
G230RC G260 SK27 HE26 TUNING
Spindle Removal
Alcohol Methanol

Meyer Distributing
Copyright.2005 Gomeyer.com and Meyer Distributing, LLC. | GoPed® is a registered trademark of goped.com | Policies